Ships from our US warehouse · 30-day returns

DC Plug and Jack Leads, 5.5 x 2.1 mm – 5 Pairs with Molded Ends

$12.99
  • 5 pairs: 5 plug leads and 5 jack leads, 10 leads in all
  • Standard 5.5 mm outer x 2.1 mm inner DC barrel connector
  • Molded ends with brass terminals; bare wire ends for splicing
  • For 12 V or 24 V DC wiring only. Not for mains power
  • Flat-rate US shipping from our US warehouse · 30-day returns
In stock

Description

Make any low-voltage lead pluggable

Each pair is a DC plug lead and a matching DC jack lead, with a bare wire tail on the far end. Splice them into a power lead, a fan, or an LED strip and you get a connector that unplugs in seconds, with no soldering of a bare barrel. Five pairs in a pack means you can wire several projects at once.

These are for low-voltage DC wiring only. They are not for mains power.

Highlights

  • Standard size: 5.5 mm outer x 2.1 mm inner, the common barrel size on many DC power supplies and small devices.
  • Plug and jack in every pair: one male lead and one female lead, so you can cut a cable in two and join it again.
  • Molded ends: the connector body is molded over the cable for a firm, tidy joint.
  • Brass terminals inside the plug and jack.
  • Rated for 12 V and 24 V DC (maker’s figure).

Works well for

  • Adding a plug-in joint to a low-voltage fan or LED lead
  • Replacing a broken connector on a low-voltage cable

How to use it

  1. Switch the power supply off and unplug it.
  2. Cut the lead you want to make pluggable, and strip a little insulation from each end.
  3. Check which wire on each lead goes to the center pin (a multimeter makes this easy), join the wires so polarity matches your supply, and insulate each joint.
  4. Check the polarity of your device against the supply before you plug in.

Specifications

Connector DC barrel, 5.5 mm outer x 2.1 mm inner
Type Male plug lead and female jack lead, wired as pairs
Construction Over-molded ends, brass terminals
Wire ends Bare, for splicing
Rated voltage 12 V or 24 V DC (maker’s figure)
Quantity 5 pairs (10 leads)

What’s in the box

  • 5 DC plug leads
  • 5 DC jack leads

Power supply, devices, wire, connectors and tools are not included.

Safety and care

  • Use with 12 V or 24 V DC only. Do not use with higher-voltage supplies.
  • Not for mains power.
  • Not for the 5 V USB-C DIY mist module kits, which must run from a 5 V USB supply only.
  • Check polarity before powering up.
  • These are not sold as watertight. If a joint will be outdoors, keep it off the ground and out of standing water, and protect it from rain.

Frequently asked questions

Do I need to solder?
You need to join the bare wire ends to your own cable. Soldering or a suitable wire connector will both work.

Do I need a ready-made extension instead?
If you only want to lengthen a lead, see our DC extension cables. More wiring parts are in Power Supplies & Cables.

Will it fit my power supply?
Measure the barrel on your supply or check its label for 5.5 x 2.1 mm and the voltage. Not sure? Email support@fogmister.com with a photo of the label.

Shipping and returns

Flat-rate shipping within the United States from our US warehouse: one shipping charge per order, shown in your cart before you pay. 30-day returns. See our Shipping Policy and Returns & Refunds.