DC Plug and Jack Leads, 5.5 x 2.1 mm – 5 Pairs with Molded Ends
- 5 pairs: 5 plug leads and 5 jack leads, 10 leads in all
- Standard 5.5 mm outer x 2.1 mm inner DC barrel connector
- Molded ends with brass terminals; bare wire ends for splicing
- For 12 V or 24 V DC wiring only. Not for mains power
- Flat-rate US shipping from our US warehouse · 30-day returns
Description
Make any low-voltage lead pluggable
Each pair is a DC plug lead and a matching DC jack lead, with a bare wire tail on the far end. Splice them into a power lead, a fan, or an LED strip and you get a connector that unplugs in seconds, with no soldering of a bare barrel. Five pairs in a pack means you can wire several projects at once.
These are for low-voltage DC wiring only. They are not for mains power.
Highlights
- Standard size: 5.5 mm outer x 2.1 mm inner, the common barrel size on many DC power supplies and small devices.
- Plug and jack in every pair: one male lead and one female lead, so you can cut a cable in two and join it again.
- Molded ends: the connector body is molded over the cable for a firm, tidy joint.
- Brass terminals inside the plug and jack.
- Rated for 12 V and 24 V DC (maker’s figure).
Works well for
- Adding a plug-in joint to a low-voltage fan or LED lead
- Replacing a broken connector on a low-voltage cable
How to use it
- Switch the power supply off and unplug it.
- Cut the lead you want to make pluggable, and strip a little insulation from each end.
- Check which wire on each lead goes to the center pin (a multimeter makes this easy), join the wires so polarity matches your supply, and insulate each joint.
- Check the polarity of your device against the supply before you plug in.
Specifications
| Connector | DC barrel, 5.5 mm outer x 2.1 mm inner |
|---|---|
| Type | Male plug lead and female jack lead, wired as pairs |
| Construction | Over-molded ends, brass terminals |
| Wire ends | Bare, for splicing |
| Rated voltage | 12 V or 24 V DC (maker’s figure) |
| Quantity | 5 pairs (10 leads) |
What’s in the box
- 5 DC plug leads
- 5 DC jack leads
Power supply, devices, wire, connectors and tools are not included.
Safety and care
- Use with 12 V or 24 V DC only. Do not use with higher-voltage supplies.
- Not for mains power.
- Not for the 5 V USB-C DIY mist module kits, which must run from a 5 V USB supply only.
- Check polarity before powering up.
- These are not sold as watertight. If a joint will be outdoors, keep it off the ground and out of standing water, and protect it from rain.
Frequently asked questions
Do I need to solder?
You need to join the bare wire ends to your own cable. Soldering or a suitable wire connector will both work.
Do I need a ready-made extension instead?
If you only want to lengthen a lead, see our DC extension cables. More wiring parts are in Power Supplies & Cables.
Will it fit my power supply?
Measure the barrel on your supply or check its label for 5.5 x 2.1 mm and the voltage. Not sure? Email support@fogmister.com with a photo of the label.
Shipping and returns
Flat-rate shipping within the United States from our US warehouse: one shipping charge per order, shown in your cart before you pay. 30-day returns. See our Shipping Policy and Returns & Refunds.















Rating & Review
There are no reviews yet.