Ships from our US warehouse · 30-day returns

Plug-In Digital Humidity Controller Outlet – Wired Sensor, US Plug

$39.99
  • Plug your fogger into it and it switches on and off around the humidity you set
  • Digital readout with up and down buttons, humidity range 0-99% RH
  • Humidity sensor on a cable, so you can place it inside your tent, tub or enclosure
  • Ready to use: built-in US plug, 110-120 V, one switched outlet
  • Flat-rate US shipping from our US warehouse · 30-day returns
In stock

Description

Let the humidity decide when your fogger runs

This plug-in controller sits between the wall and your fogger or mist maker. A sensor on a cable reads the humidity, the display shows it, and the outlet switches the connected device on and off to keep the level near the value you set.

It comes pre-wired, so there is nothing to install. Plug it in, plug your fogger into the outlet and set your target with two buttons.

Highlights

  • Pre-wired and plug-in: built-in US plug and one switched outlet, no wiring needed.
  • Digital display: shows the humidity reading at a glance.
  • Two-button setup: up and down buttons change the set value.
  • Remote sensor: the sensor sits in a gray vented housing on its own cable, so it can go where the humidity matters while the controller stays outside.
  • Wide range: works across 0-99% RH (maker’s figure).

Works well for

  • Mushroom tents and fruiting chambers
  • Greenhouses and propagation boxes
  • Reptile enclosures and vivariums
  • Humidity cabinets and storage boxes

How to set it up

  1. Place the sensor inside your enclosure, away from the fog outlet and from water that could splash it.
  2. Plug the controller into a wall outlet and plug your fogger into the controller’s outlet.
  3. Use the up and down buttons to set the humidity you want.
  4. Watch the first few cycles and adjust the sensor position or set value if needed.

Specifications

Type Plug-in humidity controller with one switched outlet
Input 110-120 V AC, US plug
Humidity range 0-99% RH (maker’s figure)
Display Digital, with up and down buttons
Sensor Humidity sensor in a vented housing, on a cable
Outlet One switched multi-standard socket (see photos)

What’s in the box

  • 1 humidity controller with built-in US plug and cable
  • 1 humidity sensor on a cable (attached)

Your fogger or mist maker is not included.

Safety and care

  • Check the label on the unit for the maximum load and make sure your device is within it.
  • For indoor use. Keep the controller itself dry and out of the water and spray.
  • Keep the unit and its wiring where animals can’t reach them.
  • Humidity needs differ by species and by crop, so check yours first.

Frequently asked questions

Can I run a mist maker from it?
Yes, it switches the power to the device plugged into it, as long as the plug fits the outlet and the device is within the load shown on the unit’s label. See our mist makers, and email support@fogmister.com if you are unsure about your device’s power draw.

Where do I put the sensor?
Inside the space you want to control, away from the fog outlet. Our mushroom chamber guide and reptile room guide cover placement ideas.

Will my fogger’s plug fit the outlet?
The outlet is a multi-standard socket, as shown in the photos. Compare your plug with the photos, and if you are unsure, email support@fogmister.com a photo of your plug.

Shipping and returns

Flat-rate shipping within the United States from our US warehouse: one shipping charge per order, shown in your cart before you pay. 30-day returns. See our Shipping Policy and Returns & Refunds.